Restroom Cleaning and Sanitation Procedures list for cleaning staff.

A. Obtain Supplies

1) Prepare all equipment and supplies required

2) Proceed to cleaning destination.

B. Prepare area properly

1) Knock on door and announce your intention to enter. If restroom is occupied, wait until it is

empty. When empty, enter.

2) Immediately post Restroom Closed sign.

3) Wear proper clothing. (gloves, safety glasses)

4) Prop door open with doorstop.

C. Toilet bowls and urinals

1) Remove all urinal screens and blocks from respective receptacles and flush before cleaning.

2) Evacuate water from bowl. Using a bowl mop, press water over the trap.

3) Apply toilet bowl cleaner and disinfectant to toilet and urinal interiors only. Allow disinfectant

cleaner to stand at least 10 minutes while other cleaning tasks are completed.

D. Dust all areas – high to low

1) Clean all dust from ceiling fans and vents, utilizing appropriate dusting tool.

2) Dust tops of doors and stall partitions.

3) Sweep floor, remove all loose trash, and empty into waste receptacles.

4) Use a putty knife to remove gum from floors and partitions.

E. Wet cleaning

1) Clean all light fixtures, mirrors, and glass surfaces with glass cleaner.

2) Wipe all partitions, tops and bottoms of doors, doorknobs, receptacles, and dispensers with

disinfectant solution.

3) Spot clean all other above-ground surfaces with disinfectant solution.

F. Clean wash basins

1) For most effective cleaning, use creme cleanser, mild phosphoric acid solution or disinfectant

solution.

2) Clean interior of sink, allowing disinfectant solution a full ten minutes of contact time for

efficacy.

HINT: High foaming cleaners will make cleaning and contact time easier.

3) Spot clean exterior surfaces, faucets, pipes and under basins. Wipe all metal surfaces dry.

4) Check operation of faucets and drains.

5) Treat drains with bacterial digestant/deodorant.

G. Clean toilet bowls and urinals – inside

1) If required, add an additional ounce of toilet bowl cleaner and disinfectant to bowl mop prior

to cleaning.

2) Clean the rim and waterline areas carefully and move into the exposed trap area.

3) Check under rim for missed mineral deposits and rust stains with lip light.

4) HINT: Acid bowl cleaners are required for mineral deposits and rust. Routine cleaning can

include non-acid cleaners.

H. Clean toilet bowls and urinals – outside

1) Spray outside and bottom surfaces with non-acid solution and wipe.

2) Wipe toilet seat with non-acid disinfectant solution.

I. Clean and empty all waste receptacles

1) Remove can liners from receptacles, wash the interiors and exteriors with disinfectant

solution, and replace can liner.

2) Empty and clean sanitary napkin receptacles with disinfectant solution. Replace liner to

comply with OSHA Bloodborne Pathogen Standards.

3) Never use your hand to press trash overflow down and into the waste receptacle.

J. Replenish all supplies

1) Refill hand soaps, toilet tissue, towels, deodorizers, and sanitary napkin dispensers.

2) If restroom has condom dispensers or other ancillary dispensers, make sure that these are

refilled.

3) Check operation of all dispensers and report malfunctions properly.

4) Check urinal screens, deodorant blocks, and gel/mist deodorants.

K. Damp mop

1) Clear area of supply cart and equipment.

2) Start in the area farthest from the door and work towards the door.

a. Make sure to mop with fresh, clean mop water.

b. HINT: Using a Neutral pH Disinfectant Cleaner can provide effective bacteria

elimination with odor counteraction.

c. A mild acidulous tile cleaner may be required for grout lines on quarry tile floors.

3) Place mop in solution and wring out, leaving mop damp. When mopping floor area around

toilets and urinals, mop thoroughly and wring out often. Change solution when necessary.

L. Odor counteraction

1) Spray bacteria-based odor counteractants liberally around toilets and urinals and let air dry.

2) Pour four ounces into each floor drain before leaving the area.

3) HINT: Saturating a paper towel with bacterial digestant deodorant and placing into waste

receptacle will aid in counteracting odors long after you have left the restroom.

Dennis Warren

Midland Chemical Co.

Leave a Comment

The Worst job Ever

It seems the worst of jobs – cleaning a toilet bowl. No one wants to do it but it has to be done so here is how to do it right. Of course you should wear disposable gloves and even goggles if using a high acid bowl cleaner to protect you from splashing. If you have well water you will want to use a high acid cleaner such as Husky 303 (a 23% hydrochloric acid bowl cleaner) if you have city water you can use a non-acid bowl cleaner such as Husky 320. In either case you will need a bows swab. Use the bowl swab to push the water over the trap (this is done by pushing the swab towards the hole in the bottom back of the toilet), By doing this you will lower the water lever in the toilet bowl and expose any stain at the normal water line. Next you will apply the bowl cleaner to the swab ad using the swab apply the cleaner to the inner bowl. Spray the outer bowl with 320 bowl cleaner using a trigger sprayer and wipe down with a disposable wiper. Now that the cleaner has time to work using your bowl swab you will again swab the inside of the toilet bowl and then flush. It is a very simple procedure but most cleaning people forget to push the water over the trap and then they wonder why they can’t get rid of the wring at or just below the water line.

Leave a Comment

Tips on Controlling Pet Odors from the Expert on Floor Care, Odor Control and Stain Removal

It seems the worst odors come from pet urine and pet waste.  To make matters worse cats in particular return to the same spot over and over.  A few months ago I was asked to help a widow from our church that had moved but needed to get the smell out of the house before putting it on the market.  The problem that caused the odor was 7 cats had also lived in the house in the basement.  Needless to say the smell was overwhelming. The first Thing I did was mix a product called Rid’z Odor 3 OZ of product to 1 gal of water in a garden sprayer and sprayed all the walls in the basement, the floor and the rafter also in the basement.  Then I sprayed all carpet surfaces on the main floor with Uric Acid Eradicator.  The next day when everyone came back to work on the house everyone committed that the smell was gone.  Now that the carpet was completely dry I spread baking soda on the carpet as it is a great absorber and will just vacuum up the next time the carpet is vacuumed to catch any additional hidden odors.   A week later I was back at the house and the odors did not return.    Both Rid’s Odor and Uric Acid Eradicator  contain a live bacteria that seek out odor causing bacteria and feed on it till there is nothing left then the microscopic live bacteria dies off.

As a side note The Uric Acid Eradicator is also great for eating the gunk that can clog the drain and cause odors.

Suggested products:

Rid’z Odor Quarts

Uric Acid Eradicator Quarts and Gal.

See our web site www.midlandchemical.com

Leave a Comment

Floor finishing Tips from the Expert on Floor Care, Odor Control and Stain Removal

Stripping and re-coating a tile floor is hard enough. Try these simple steps to make job easier and to get better results:

1. Completely flood the floor with the stripping solution and do not let any part of the area you are stripping to start drying until it has been scrubbed and you are ready to mop, squeegee or wet vacuum up.
2. Always put a trash liner in mop bucket before pouring wax in so you do not have to clean wax out of bucket when you complete job.
3. Only put finish all the way to wall on every other coat so as not to create a build up that will later have to be hard to strip off. After all, no one walks within 9 to 12 inches of the wall, so how much protection does that part of the floor need?
4. Finally, you should only use a synthetic mop head that will not lint when applying finish and when the job is complete you should store in a plastic bag for your next job. Just dip in warm water and wring out before its next use. A good finish mop can last for 20 to 30 jobs.
Try these tips and your job will look better and will be easier on you.

Suggested Products:

Great White Finishing Mop

Leave a Comment

What we do…

Serving the needs of local businesses and home owners for over 18 years, Midland Chemical Company has earned its reputation by providing superior products at great prices. Check out our catalog to see the wide variety of items we offer — from air freshener to ziploc bags; we have what you need.

Leave a Comment